Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 224 / 1506

atm pvc
Syntax
To create a PVC on an ATM interface when using the aal5snap , aal5autoconfig , or
aal5mux ip encapsulation type:
atm pvc vcd vpi vci encapsulation [ cbr cbr | peak [ average burst [ rt ] ] ]
[ oam [ seconds | cc [ segment | end-to-end ] { source | sink | both } ] ]
[ inArp [ minutes ] ]
no atm pvc vcd
To create a PVC on an ATM interface when using the aal5all , aal0 , or ilmi
encapsulation type:
atm pvc vcd vpi vci encapsulation [ cbr cbr | peak [ average burst [ rt ] ] ]
no atm pvc vcd
To use a profile to apply encapsulation and traffic-shaping parameters to a bulk range
of PVCs configured for a dynamic ATM 1483 subinterface:
atm pvc encapsulation [ cbr cbr | peak [ average burst [ rt ] ] ] [oam seconds ]
no atm pvc
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
From Interface Configuration or Subinterface Configuration mode, creates a PVC on
an ATM interface. The
no version removes the specified PVC.
From Profile Configuration mode, applies encapsulation, traffic-shaping, and OAM
parameters to the range of PVCs configured on a static ATM AAL5 interface for use
by a dynamic ATM 1483 subinterface. The
no version restores the default service
type, UBR, on the VC range.
NOTE: The optional peak , average , and burst parameters configure traffic-shaping
parameters for the circuit. The allowable traffic-shaping features and range
specifications depend on the line module capabilities.
Options
■
vcd —Virtual circuit descriptor that is an identifier for the VC in other commands;
in the range 1–2147483647
■
vpi —Virtual path identifier of this PVC. The allowable numeric range depends
on the line module capabilities and current configuration. The VPI and VCI cannot
both be set to 0; if one is 0, the other cannot be 0.
■
vci —Virtual circuit identifier of this PVC. The allowable numeric range depends
on the line module capabilities and current configuration. The VPI and VCI cannot
both be set to 0; if one is 0, the other cannot be 0.
182 ■
atm pvc
JUNOSe 11.1.x Command Reference Guide A to M