Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 362 / 1506

bridge route
Syntax
[ no ] bridge bridgeGroupName route { ip | mpls | pppoe }
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Enables routing of IP, MPLS, or PPPoE packets in a specified bridge group when
concurrent routing and bridging (CRB) is enabled for all bridge groups on the router.
The command uses the routing table entries to determine the path on which to send
the packet toward its final destination. The
no version disables routing of the specified
protocol in the specified bridge group.
If you issue this command for a protocol that is not currently configured in the
interface stack for that bridge group, the bridge group discards (drops) those packets.
NOTE: The bridge route command is available for a bridge group only after you
issue the bridge crb command to enable CRB for all bridge groups on the router.
The bridge route command is not valid for bridge groups configured as VPLS
instances. If you attempt to issue the bridge route command for a VPLS instance,
the router displays an error message and rejects the command.
Options
■
bridgeGroupName —Name of a bridge group specified with the bridge command
■
ip — Specifies that the bridge group routes IP packets
■
mpls—Specifies that the bridge group routes MPLS packets
■
pppoe—Specifies that the bridge group routes PPPoE packets
Mode
Global Configuration
320 ■
bridge route
JUNOSe 11.1.x Command Reference Guide A to M