Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 1440 / 1506

mpls-relay atm cell-packing mcpt-timer
Syntax
mpls-relay atm cell-packing maxCellsPerPacket mcpt-timer timerIdentifier
no mpls-relay atm cell-packing
Release Information
Command introduced in JUNOSe Release 10.2.0.
Description
Configures cell concatenation parameters for an ATM port to calculate the maximum
number of ATM cells that the router can concatenate in a single packet and the unique
identifier of the ATM Martini cell packing timer that you want to use to detect timeout
of the cell collection threshold. You can configure this command on the ATM port
only after you associated a pseudowire with the port by using the mpls-relay or route
interface tunnel command. You can use this command only on an ATM port (ATM
AAL5 over ATM major interface). The
no version disables cell concatenation, which
is the default behavior.
Options
atm—Configures ATM interface parameters for MPLS cross-connect
■
■
maxCellsPerPacket —Maximum number of ATM cells in the range 1–190 that the
router can concatenate in a single VCC cell relay-encapsulated packet and transmit
on an MPLS pseudowire connection; default value is 1 cell per packet
■
timerIdentifier —Integer in the range 1–3 that identifies which of the three ATM
Martini cell packing timers (timer 1, timer 2, or timer 3) you want to use to detect
timeout of the cell collection time threshold; default value is 1. When the timer
expires, the router forwards the packet even if the number of concatenated ATM
cells in the packet is fewer than the specified maximum number of cells per
packet.
Mode
Interface Configuration
Related Topics
■
Multiple ATM Virtual Circuits over a Single Pseudowire Overview and Multiple ATM
Virtual Circuits over a Single Pseudowire Example in the JUNOSe BGP and MPLS
Configuration Guide
1398 ■
mpls-relay atm cell-packing mcpt-timer
JUNOSe 11.1.x Command Reference Guide A to M