Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 203 / 1506

atm bulk-config
Syntax
atm bulk-config bulkConfigName [ vc-range vpiStart vpiEnd vciStart vciEnd ]*
no atm bulk-config bulkConfigName [ vc-range vpiStart vpiEnd vciStart vciEnd ]
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Configures a range of ATM PVCs for use by a dynamic ATM 1483 subinterface, and
assigns a name to the virtual circuit (VC) range. Each VC range consists of one or
more nonoverlapping VC subranges. A VC subrange is a group of VCs that resides
within the specified VPI and VCI ranges. You can configure multiple VC ranges on
an ATM AAL5 interface. The
no version removes the specified VC range (including
all subranges in the range) from the ATM AAL5 interface or the specified subrange
from the VC range. The
no version also removes any overriding profile assignments
for ATM PVCs within the deleted VC range or VC subrange.
NOTE: The total number of VCs configured with the atm bulk-config command
cannot exceed the maximum ATM VC capacity of the line module you are using. For
details about the ATM VC capacity of supported line modules, see
JUNOSe Release
Notes, Appendix A, System Maximums .
Options
■
bulkConfigName —Name of the VC range; string of up to 80 characters
■
vpiStart —Starting virtual path identifier (inclusive) of the VC subrange you are
configuring
■
vpiEnd —Ending virtual path identifier (inclusive) of the VC subrange you are
configuring
■
vciStart —Starting virtual circuit identifier (inclusive) of the VC subrange you are
configuring
■
vciEnd —Ending virtual circuit identifier (inclusive) of the VC subrange you are
configuring
■
*—Indicates that one or more parameters can be repeated multiple times in a
list in the command line
Mode
Interface Configuration
atm bulk-config
■ 161
Chapter 2: A Commands