Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 60 / 1506

Table 4: Interface Types and Specifiers for E120 Router and E320 Router (continued)
Example Interface Specifier Description Interface Type
sonet 3/0/0 slot / adapter / port
■
slot —Number of the chassis slot in the
range 0–5 (E120 router) and 0–5 or
11–16 (E320 router)
■
adapter —Identifier for the IOA within the
chassis slot, either 0 or 1, where:
■
0 indicates that the IOA is installed
in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
■
1 indicates that the IOA is installed
in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
■
port —Port number on the IOA
Section layer
of a
SONET/SDH
interface sonet – section
layer
tenGigabitEthernet
4/0/1.20 slot / adapter / port [. subinterface1 [. subinterface2
] ]
■
slot —Number of the chassis slot in the
range 0–5 (E120 router) and 0–5 or
11–16 (E320 router)
■
adapter —Identifier for the IOA within the
chassis slot. 0 indicates that this a
full-height IOA.
■
port —Port number on the IOA
The meaning of the subinterface variables
depends on the configuration context. You
can configure 10-Gigabit Ethernet interfaces
with or without VLANs.
■
VLANs:
■
subinterface1 —Number of the VLAN
subinterface in the range
1–2147483647; no more than 4096
VLAN subinterfaces per 10-Gigabit
Ethernet physical port
■
subinterface2 —When using PPPoE,
the number of the PPPoE
subinterface in the range
1–2147483647; no more than
16,000 PPPoE subinterfaces per
10-Gigabit Ethernet line module
■
No VLANs:
■
subinterface1 —When using PPPoE,
the number of the PPPoE
subinterface in the range
1–2147483647; no more than
16,000 PPPoE subinterfaces per
10-Gigabit Ethernet line module
■
subinterface2 —Not used
IEEE
802.3ae
10-Gigabit
Ethernet
(GE)
interface tenGigabitEthernet
18 ■
Interface Types and Specifiers
JUNOSe 11.1.x Command Reference Guide A to M