Johnson Controls YVAHP072B31S, Service Manual

Page: 695 / 1796

Service Manual
1-679
INSTALLATION
2 Add, Change, and Delete Units
[Procedure]
(1) Current result acquisition in operation ratio function
(2) Stop operation ratio function
(3) Exit the management software
(4) Backup data
(5) Con
¿ rm connection and add, change, and delete units
(6) Restart the adapter
(7) Restart the management software
(8) Add and change remote controller groups
(9) Add and change groups
(10) Add and change blocks
(11) Add and change tenants
(12) Check controlling and monitoring settings
(13) Set of operation ratio function
(14) Restart operation ratio function
Ƒ (1) Current result acquisition in operation ratio function
Calculate the operation ratio using current settings in cases where unit settings become modi ¿ ed or
changed.
(a) Click on [Ope.Ratio] > [Ope. ratio setting] > [Accumulated data setting].
(b) Click on [Acquire untaken data] to activate calculation.
NOTE:
Ɣ Calculation might require some time, depending on the amount of data.
Ɣ In cases of calculation information output, refer to Service and Maintenance 8 Troubleshooting.
NOTICE:
For all other hours of the day, do not attempt to start this procedure within 15 minutes prior to the stroke of
the next hour. If the calculation period is set for a 24 hour span, do not perform this procedure within the
hours of midnight and 2:00am, local time. If the calculation period is set for a one hour time window, the
operation ratio calculation (ope. ratio cal function) will take effect for the following hour of operation.
NOTICE:
For all other hours of the day, do not attempt to start this procedure within 15 minutes prior to the stroke of
the next hour. If the calculation period is set for a 24 hour span, do not perform this procedure within the
hours of midnight and 2:00am, local time. If the calculation period is set for a one hour time window,
the operation ratio calculation (ope. ratio cal function) will take effect for the following hour of operation.