Johnson Controls YVAHP072B31S, Service Manual

Page: 615 / 1796

Service Manual
1-599
INSTALLATION
9 Layout Register
Layout is a set of units that can be monitored or controlled (or both) by this system. Total up to 256 icons for
Block, Group, Unit (IU), facility unit can be located within a single layout. To monitor or control the unit and
facility unit on the Layout screen, the units must be registered into a layout.
Setup of the Layout Register,
9
is a local matter. Set the following items as necessary.
[Concept]
Layout information shows Block, Group, Unit, and Facility units as a ground or air view plan shortcut (*),
and then monitors, controls, and shows any apparent trends.
2-6-5.bmp
Layout Information
Group, Block
Registration Information
Block
Group Group Group
Unit Facility Unit Unit Unit
* The Group, Block, set as represented by an icon in the layout are
required to be registered in advance.
Master layout is used to show multiple layouts.
Create a master layout if necessary.
NOTE:
In the event that the Master layout was not created when using multiple
layouts, because the Master layout cannot be automatically displayed
when an alarm goes off, in certain cases on screen, the unit with the
alarm cannot be identi
¿ ed. (The unit with the alarm is displayed with a
scroll and status bar.)
When using a unit that does not have a louver or a facility unit, do not
create Master layout.
Layout (3rd Floor)
Layout (2nd Floor)
Layout (1st Floor)