Service Manual
1-139
INSTALLATION
7HVW5XQ
Test Run Screen
9.1 Before
Test
Run
9HULI\WKDWWKHUHDUHQRSUREOHPVZLWKWKHLQVWDOODWLRQDQGGRQRWSHUIRUP7HVW5XQXQWLODOOWKHIROORZLQJ
conditions have been resolved.
5HIHUWRWKH,QVWDOODWLRQDQG0DLQWHQDQFH0DQXDOIRUWKHRXWGRRUXQLWIRUGHWDLOVRQ7HVW5XQRSHUDWLRQV
from the outdoor unit.
Verify that refrigerant piping and the communication cable are connected to the same refrigerant cycle
V\VWHP,IQRWLWZLOOFDXVHDQDEQRUPDORSHUDWLRQDQGGDPDJHWRLQVWUXPHQWDWLRQ
9HULI\WKDWHOHFWULFDOUHVLVWDQFHLVPRUHWKDQRQHPHJDRKPE\PHDVXULQJWKHUHVLVWDQFHEHWZHHQ
ground and the terminal the terminus for electrical components. If the electrical resistance is less than
RQHPHJDRKPGR127RSHUDWHWKHV\VWHPXQWLOWKHHOHFWULFDOFXUUHQWRXWÀRZWRJURXQGLVGHWHFWHGDQG
repaired. Do not introduce any high voltage to the terminals of the communication cables
7%>$%DQG@
(2) Verify that each wire is connected correctly at the correct phase for the power supply. If it is incorrectly
FRQQHFWHGWKHXQLWZLOOQRWRSHUDWHDQGWKHZLUHGFRQWUROOHUZLOOGLVSOD\WKHDODUPFRGH³´,QWKLV
FDVHFKHFNWKHSKDVHIRUWKHSULPDU\SRZHUVXSSO\DFFRUGLQJWRWKH³$WWHQWLRQ´ODEHODI¿[HGWRWKHEDFN
VLGHRIWKHVHUYLFHFRYHU7KHQZLWKWKHSRZHUVXSSO\WXUQHG2))DWWKHSRZHUVXSSO\UHPDNHWKH
necessary connections.
&KHFNWRHQVXUHWKDWWKHPDLQSRZHUVXSSO\KDVEHHQWXUQHG21IRUPRUHWKDQKRXUVWRZDUPXS
the compressor oil by the crankcase heater.
(4) Verify that all DIP Switch settings are correct. Refer to Section 8.5 “DIP Switches Setting”.
9.2 Test
Run
$IWHUDOOLQVWDOODWLRQZRUNLVFRPSOHWHG7HVW5XQVKRXOGEHSHUIRUPHG
(1) Check to ensure that stop valves (gas and liquid) for the outdoor unit are fully opened.
:KHQHYHULQGRRUXQLWVDUHFRQQHFWHGWRWKH95)V\VWHPSHUIRUPWKH7HVW5XQIRUWKHLQGRRUXQLWVRQH
by one sequentially and then check the refrigerant piping system and the electrical wiring system for
FRQIRUPLW\,IWKHVHPXOWLSOHLQGRRUXQLWVDUHRSHUDWHGVLPXOWDQHRXVO\V\VWHPFRQIRUPLW\FDQQRWEH
YHUL¿HG
(3) Perform the Test Run in accordance with the following procedure. Ensure that the Test Run is carried
out without any problem. The following procedure shows a case where a wired controller is utilized.
,IRWKHUFRQWUROOHUVDUHDFWLYDWHGLQVWHDGUHIHUWRWKH,QVWDOODWLRQDQG0DLQWHQDQFH0DQXDOIRUWKRVH
other controllers.
NOTE:
The outdoor unit may not be operated depending on the indoor and outdoor temperature conditions.
5HIHUWRWKH,QVWDOODWLRQDQG0DLQWHQDQFH0DQXDOIRURXWGRRUXQLWVIRUGHWDLOV
(a) Press and hold “Menu” and “Back/Help” simultaneously for at least 3 seconds.
The Test Run menu will be displayed.
Ɣ
The Test Run menu will be displayed.
Back
Adj.
Sel.
ON
Rtrn
Test Run Setting: 2 units
MODE
SPEED
AUTO
COOL
NOTE
:KHQWKH³XQLW´LVGLVSOD\HGWKHDXWRDGGUHVV
function may be working.
Cancel
³7HVW5XQ´
mode and reset.
Summary of Contents for YVAHP072B31S
