Johnson Controls YVAHP072B31S, Service Manual

Page: 379 / 1796

Service Manual
1-363
INSTALLATION
[3.3 Installation Procedures]
1. Insert the edge of the slotted screwdriver into the groove at the bottom of the holding bracket, push and turn the
slotted screw driver to separate and remove the controller from the holding bracket.
Groove Part
Figure Seen from Bottom Side
Slotted
Screw Driver
Approx. 0-15/64 inch
(6mm)
Groove for Attaching Controller
Rear Cover
3. Installation Work
[3.1 Selection of Installation Place]
1. Select a suitable staging area in which to assemble the unit. With the customer’s approval, determine the best
placement of the assembled unit. Choose a safe, sequestered area where the inquisitive can't reach it, and keep it
out the way of any direct air discharge.
[3.2 Prior to Installation]
1. This packing contains the following parts.
[A] Wired Controller (Qty.: 1 - For Operation Control)
[B] Screw <M4x16L> (Qty.: 2, For securing the mounting bracket to the wall.)
[C] Operation Manual (Qty.: 1)
The box is to verify your work. Check-off each task to verify that it has been done.
2. Brand Label
Select the accessory brand label according to the production order. (HITACHI or YORK)
Attach the accessory brand logo label to this area.
OK
Menu
Back/Help ECO
On/Off
O
This Area
Approx. 5/16 Inch
(8mm)
More than
2 Inches
(51mm)