Husqvarna MS 630 2011 I.E., Manual

Page: 98 / 304

1
3
2
EN - 40
REMOVING THE REAR WHEEL
Unscrew the nut (1) of the wheel axle (3) and extract it.
It is not necessary to loosen the chain tensioners (2); in
this way, the chain tension will remain unchanged after
reassembly. Extract the complete rear wheel, keeping the
spacers located at the hub sides.
To reassemble, reverse the above procedure remember-
ing to insert the brake disc into the calliper.
Note *:
Do not operate the rear brake pedal when the wheel has
been removed; this causes the calliper pistons to move
outwards.
After removal, lay down the wheel with brake disc on
top.
After reassembly, depress the brake pedal until the pads
are against the brake disc.
TYRES
Care should be taken to keep the tyres properly inflated.
See "Technical data" chart at the beginning of the manu-
al for correct tyre inflation pressure.
Replace the tyre if its wear exceeds reference values on
the table below.
MINIMUM HEIGHT
OF THE TREAD
FRONT 0.12 in. (TE); 0.08 in. (SMS)
REAR 0.12 in. (TE); 0.08 in. (SMS)