edge switch 2/24 service manual
3–31
Repair Information
Switch Reset
To reset the switch from the front panel:
1. Press and hold the IML/RESET button for approximately ten seconds.
— After holding the button for three seconds, the amber ERR LED blinks at
twice the unit beaoning rate.
— After holding the button for ten seconds, the ERR LED stops blinking, and all
front panel LEDs illuminate.
2. Release the button to reset the switch. During the reset:
— The green power (PWR) LED on the switch front panel illuminates.
— The amber system error (ERR) LED on the switch front panel blinks
momentarily while the switch is tested.
— The green LEDs associated with the Ethernet port blink momentarily while
the port is tested.
— The blue/green and amber LEDs associated with the ports blink momentarily
while the ports are tested.
— The switch-to-HAFM server Ethernet link drops momentarily and the
following occur at the Hardware View:
— As the network connection drops, the status table turns yellow, the Status
field displays
No Link
, and the State field displays
Link Timeout
.
— The status bar at the bottom of the window displays a grey square,
indicating switch status is unknown.
— Illustrated FRUs disappear, and appear again as the connection is
re-established.
