Appendix 1 Alarm List
365
Appendix
No.
Message
Contents
040
Chamfering amount too
large of latitude axis in
threading.
Chamfering amount of latitude axis in G92 was greater
than the distance between start point and end point.
Modify the program.
041
Illegal level select
In the level selection command, two or more axes in
the same direction are selected. Modify the program.
042
Metric/inch conversion
command error
Metric/inch conversion code G20/G21 was not
specified in an independent block at the beginning of
the program or execute metric/inch conversion in
subprogram call. Modify the program.
043
Reference return incomplete Reference return can't be performed normally because
the start point is too close to the reference position or
the speed is too slow. Separate the start point far
enough away from the reference position. Or specify a
sufficiently fast speed for reference point return.
044
Reference return incomplete In auto operation halt state, manual reference point
return can't be performed.
045
The axis is not at reference
point
The axis does not return to reference point in G27.
Check the program content.
046
G28 found in sequence
return
A command of program restart was specified without
the reference position return operation after power-on
or emergency stop, G28 was found during search.
Perform the reference position return.
047
The axis does not turn to
reference point
Didn't return to reference point before cycle start.
Perform the reference return first.
048
Illegal reference point
Address P specifies other values than 2~4 in
G30.\nModify the program.
051
G37 arrival signal not
asserted
In auto tool compensation function (G36,G37),within
the area specified by parameter. Measurement
position reach signal (XAE or EAE) is not turned on.
This is due to a setting or operator error.
052
Offset number not found in
G37
Auto tool compensation (G36\G37) was specified
without T code. Modify the program.
053
T code not allowed in G37
T code and auto tool compensation (G36, G37) was
specified in the same block. Modify the program.
054
Illegal axis command in G37 In auto tool compensation function (G36,G37),an
invalid axis is specified or the command is incremental.
Modify the program.
055
G37 function is disabled
Auto tool compensation function is disabled (G36,
G37) with reference to PARA.6240#7 IGA. Modify the
program.
058
G31 not allowed in G99.
G31 skip cutting is commanded in the per revolution.
Modify the program
059
G31 not allowed in tool
radius compensation mode.
In tool nose radius compensation mode, specify skip
cutting command. Modify the program.
061
Illegal P command in G10
In setting an offset amount by G10, the offset number
Summary of Contents for 988T
