GSK 988T, User Manual

Page: 377 / 416

Appendix 1 Alarm List
363
Appendix
Appendix 1 Alarm List
1.1 Program Alarms (P/S Alarms)
No. Message Contents
000
Emergency stop alarm, ESP
input open circuit
Recover ESP signal input to clear alarm.
001 Part prog. open failure Reset to clear alarm or power-on again.
002
Single block exceeds 256
characters Characters excessive in single block; modify the
program.
003
Data exceeds permissive
range Input data exceeds permissive range, or the specified
data exceeds 8 digits; modify the data.
004
Address not found With number or symbol other than address at the
beginning of a block. Modify the program.
005
No data follows address No data follows address or expression format following
address checks error, without brackets. Modify the
program.
006
Illegal use of negative sign Sign "-" was input after an address with which it can't
be used, or two or more "-" was input. Modify the
program.
007
Illegal use of decimal point Decimal point"." was input after an address with which
it can't be use, or two or more "." was input. Modify the
program.
008
Input illegal address Input unusable address in significant area. Modify the
program.
009
Incorrect G code Specify improper G code or that with functions not
provided. Modify the program.
010
Address repetition error Specify the same address twice or more in a block, or
specify two or more G codes in same group in a block.
Refer to para. 3403#6 AD2. Modify the program.
011
Command can't run in MDI
mode Command cannot run in MDI mode. Modify the
program.
012
Too many M codes Multiple M codes can't be specified in a block, referring
to para.3404#7 M3B. Modify the program.
014 Divided by zero Divisor was 0(including tan90°). Modify the program.
017
Para. modified failure. Check that the para. file be abnormal. User partition is
possibly damaged
！
018 Part prog. operation failure Reset to clear alarm.
019
End of record Specify end symbol (%) of record, or not specify end of
program, referring to para.3404#6 EOR. Modify the
program.
020 DNC time out DNC transmission failure; Please check.
021
Feedrate out of range Feedrate was not commanded to a cutting feed or the
feedrate was inadquate. The meaning of F is
determined by G98/G99, please check current modal