GSK 988T, User Manual

Page: 36 / 416

GSK988T Turning CNC System User Manual
22
Ⅰ
Programming
-
*
/
Skip command, selectively skip the commands
following the character
.
Floating point number with number
=
Variable assignment
[
] Prior operation of expression and conditional
judgement prompt
#
Variable
; End of program in the block, following annotation
(
Annotation start in the block. Example: (X20.)W-10.;
not execute X20.
)
Annotation end in the block
%
End of program
Note 1: The 2-digit following the decimal point of F value is value, and the more following the two-digit is
ignored.
Note 2: The expression can follow the word, the value counted by the expression is taken as the value of the
word, and the expression should have[] , and there must not be the space between the word and the
expression. For example X[#1-#110] Z[#1+SIN[#120]].
*1
）：
When the address values in the above table, X, Y, Z, C, A, B, C, U, V, W, H, I, J, K, R are taken
as word address, their value ranges are controlled by the following parameters:
（
1
）
No.0000#2 INI
INI input unit
0
：
metric
1
：
inch
（ 2 ） No.1006#0 ROTx
ROTx set linear axis or rotary axis
0
： linear axis
1
：
rotary axis
（ 3 ） No.0004#1 ISC
ISC set least input unit and least command increment
Table 1-5-2 set least input unit and least command increment
ISC Least setting unit For short
0 0.001mm, 0.001deg or 0.0001inch IS-B
1 0.0001mm, 0.0001deg or 0.00001inch IS-C
Table 1-5-3 least command unit and value range
Address Parameter setting Least
command
unit Range
X,Y,Z,C,A,B,C,U,V,W,H ROTx=0
Rotary axis
Rotary
axis is not ISC=0
ISB 0.001deg
-99999.999
～
99999.999 deg