GSK 988T, User Manual

Page: 361 / 416

Chapter
Ⅺ
Parameters
347
Ⅱ
Operation
『
Default Setting
』
: 10
『
Value Range
』
:
SETTING UNITS IS-B IS-C UNITS
Metric input 0.001 0.0001 mm
Inch input 0.0001 0.00001 inch
SETTING RANGE IS-B IS-C
Metric input
Inch input
0
～
9 999 999 0
～
99 999 999
The parameter sets Set the maximum allowable tool wear compensation value.
When the set absolute value of the tool wearing compensation value exceeds the maximum value, it
alarms:
Input from MDI……alarm: too many digits. Exceed range (XXXX——XXXX) (input range is in the
bracket).
Input through G10……alarm: The offset value input by G10 is out of the specified range.
11.15 Parameters Related to the Canned Cycle
The setting unit of canned cycle parameter is shown as follows:
IS-B IS-C UNITS
Metric input 0.001 0.0001 mm
Inch input 0.0001 0.00001 inch
11.15.1 Parameter of the Drilling Canned Cycle
#7 #6 #5 #4 #3 #2 #1 #0
5102 MRC
『
Modification authority
』
:Equipment management authority
『
Default Setting
』
: 0000 0000
#1 MRC A target figure other than monotonically increasing or
monotonically decreasing in G71 and G72 or that on Z axis in G73
0: No alarm is issued
1: An alarm is issued
#7 #6 #5 #4 #3 #2 #1 #0
5104 FCK
『 Modification authority 』 :Equipment management authority
『
Default Setting
』
:0000 0000
#2 FCK : The machining profile in multiple repetitive cycle(G71,G72,G73) is
0: Not checked
1: Checked
5110 C-axis clamp M code in drilling canned cycle(CMD)
『
Modification authority
』
:Equipment management authority
『
Default Setting
』
: 0