GSK 988T, User Manual

Page: 359 / 416

Chapter
Ⅺ
Parameters
345
Ⅱ
Operation
1: Compensated by the tool movement
#6 LWM Tool offset(when LGT=1)
0: Is done in the T code block
1: Is done together with the axis movement
#7 #6 #5 #4 #3 #2 #1 #0
5003 LVC CCN
『 Modification authority 』 : Equipment management authority
『
Default Setting
』
: 0000 0000
#2 CCN When automatic reference postion return(G28) is specified in tool nose
radius compensation
0: Comoensation is cancelled in movement to the intermidiate position
1: Comoensation is not cancelled in movement to the intermidiate position,but cancelled in
movement to the reference postion
#6 LVC Offset value of tool offset 0 except in MDI mode Tool offset value is
0: Not cleared but held by reset
1: Cleared by reset
#7 #6 #5 #4 #3 #2 #1 #0
5004 ORC
『 Modification authority 』 : Equipment management authority
『
Default Setting
』
: 0000 0000
#1 ORC Tool offset value
0: Set by the diameter specification(Can be set in only the axis under diameter programming)
1: Set by the radius specification
#7 #6 #5 #4 #3 #2 #1 #0
5005 PRC
『
Modification authority
』
: Equipment management authority
『
Default Setting
』
: 0000 0000
#2 PRC iDirect input of tool offset value
0: Not use a PRC signal
1: Use a PRC signal
#7 #6 #5 #4 #3 #2 #1 #0
5006 TGC OIM
『
Modification authority
』
: Equipment management authority
『 Way of Validating 』 : After power-on
『
Default Setting
』
: 0000 0000
#0 OIM When the unit is switched between the inch and metric systems, automatic tool
offset value conversation is
0: Not performed
1: Performed
#1 TGC When a T code is specified in G50, G04 or G10
0: No alarm occurs
1: Alarm occurs
Note: When LGT is 0, the offset is executed in T code block, and there isn’t any connection with
the parameter.