GSK 988T, User Manual

Page: 372 / 416

GSK988T Turning CNC system User Manual
358
Ⅱ
Operation
#5 NCC When a travel command is issued for the PLC-controlled axis according to
the program
0: An alarm is issued when PLC controls the axis with an axis control
comang.When the PLC does not control the axis,a CNC command is enabled
1: An alarm is issued unconditionally.
#7 #6 #5 #4 #3 #2 #1 #0
8002 FR2 FR1 PF2 PF1 F10 DWE RPD
『
Default Setting
』
: 0000 0000
#0 RPD Rapid traverse rate for PLC-controlled axes
0: Feedrate specified with para NO.1420
1: Feedrate specified with the feedrate data in an axis control command
#1 DWE Minimum time which can be specified in a dwell command in PLC axis
control when the increment system is IS-C
0: 1ms
1: 0.1ms
#3 F10 Least increment for the feedrate for cutting feed(per minute) in PLC axis control
F10 Metric input Inch input
0 1mm/min 0.01inch/min
1 10mm/min 0.1inch/min
#4,#5 PR1, PR2 In PLC axis control, the least increment unit of cutting feed
PF2 PF1 Speed
0 0 1/1
0 1 1/10
1 0 1/100
1 1 1/1000
#6,#7 FR1, FR2 the feedrate unit of feed per rotation in PLC axis control
FR2 FR1 Metric input Inch input
0 0
1 1
0.0001mm/rev 0.000001inch/rev
0 1 0.001mm/rev 0.00001inch/rev
1 0 0.01mm/rev 0.0001inch/rev
#7 #6 #5 #4 #3 #2 #1 #0
8003 PIM
『
Way of Validating
』
: After power-on
『 Default Setting 』 : 0000 0000
#0 PIM If PLC control axis is linear axis, the control commands are
0: Affected by inch system/metric system
1: Not affected by inch system/metric system
#7 #6 #5 #4 #3 #2 #1 #0
8004 NDI NCI DSL JFM NMT CMV