GSK 988T, User Manual

Page: 277 / 416

Chapter
Ⅳ
Editing and Managing Programs
263
Ⅱ
Operation
9
Pasting a block;
Simultaneously press and to past the copied or cut block.
4.4 Block Comment
When a block is commented, “EOB” is pressed with “;” behind the block, the content following “;”
is the comments.
Example:
O0001 ；
G50 X0 Z0
；
set the coordinate zero;
G00 X100 Z100
；
rapid traverse to the position X100, Z100
；
M30
；
In the above program, the comment is added to the 2nd and the 3rd block, among which the
content following the 1st semicolon is the comment, and the 2nd is the block’s end character which is
automatically added after a block is completed to press the key.
Note: The Chinese comment must be edit by a PC because the system does not support Chinese input.
4.5 Generating a Block Number
In the program, the block number can be edited or not edited; the program is executed based on
the editing sequence of the block (except calling).
In the setting windows, CNC setting window, when “auto generating number” switch is off, CNC
can’t auto generate the block number, the block number can be edited manually during programming.
In the setting window, CNC setting window, when “auto generating number” switch is on, CNC
auto generates the block number; during editing, press to enter a new line and auto generate
the number of the next block, the increment value of the block number is set by CNC Value parameter
#3216.
4.6 Background Editing a Program
In Auto or DNC mode, press to enter the program window, at the moment, the user can
open the program to edit or create a program to edit, and the operations is the same those of the
above.
Note 1: The user cannot edit the program which is running currently;
Note 2: In Auto or DNC mode, the user cannot press when the background editing program is
executed, otherwise, the running program resets to stop.