GSK 988T, User Manual

Page: 327 / 416

Chapter
Ⅺ
Parameters
313
Ⅱ
Operation
0: Disabled
1: Enabled
Note: Parameter DLZ (No.1002#1) is valid when it is “0”. When DLZ (No.1002#1) is “1”, there is no
connection with the parameter, and setting the reference position free of the link stopper is valid
for all axes.
#3 HJZx Manual reference position return with reference position already set was
performed.
0: With deceleration dogs
1: Using rapid traverse without deceleration dogs.
#7 #6 #5 #4 #3 #2 #1 #0
1006 ZMIx DIAx ROSx ROTx
『
Way of Validating
』
: After power-on
『 Parameter Type 』 : Bit axis
『
Default Setting
』
: 0000 0000
#0, #1 ROTx, ROSx Set linear or rotation axis
ROSx ROTx Content
0 0
Linear axis
Metric/inch conversion
All coordinate values are of the linear axis type.
The stored pitch error compensation is of the linear axis type.
0 1
Rotary axis (type A)
No metric/inch conversion
The machine coordinate value displays in 0
～
360° cycle.
The stored pitch error compensation is of the rotary axis type.
Automatically return to the reference position at the direction of the reference
position return (G28 and G30), the traverse amount can not exceed one turn.
1 0 Invalid setting
1 1
Rotary axis (type B)
No metric/inch conversion
The machine coordinate value, the relative coordinate value and the
absolute coordinate value are in the linear axis, which can’t display in cycle
of 0
～
360°.
The stored pitch error compensation is of the linear axis type.
The cycle function and the indexing function of the rotation axis can not be
used at the same time.
#3 DIAx Either a diameter or radius is set to be used for specifying the amount of
travel on each axis
0: Radius
1: Diameter
#5 ZMIx The direction of reference postion return
0: Positive
1: Negative
#7 #6 #5 #4 #3 #2 #1 #0
1008 RRLx RABx ROAx