Fujitsu MB90460 Series, Hardware Manual, Page: 261 / 739

242
CHAPTER 12 16-BIT RELOAD TIMER
12.4.4 16-bit Reload Register (TMRD0/TMRD1)
The 16-bit reload register (TMRD0/TMRD1) sets a reload value in the 16-bit down
counter. The value written to this register is loaded into the down counter, and the
value is counted down.
■
16-bit Reload Register (TMRD0/TMRD1)
Figure 12.4-5 shows the 16-bit reload registers (TMRD0/TMRD1).
Figure 12.4-5 16-bit Reload Register (TMRD0/TMRD1)
The initial value of the counter is set in this register when counting is disabled (TMCSRL0/
TMCSRL1:CNTE = 0), regardless of the operating mode of the 16-bit reload timer. When counting is
enabled (TMCSRL0/TMCSRL1:CNTE = 1) and the counter is started, counting down starts from the value
written to this register.
In reload mode, the value set in the 16-bit reload register (TMRD0/TMRD1) is reloaded into the counter
when an underflow occurs, and counting down continues. In single-shot mode, the counter stops at FFFF
H
when an underflow occurs.
Notes:
• Write a value to this register in the counter stop (TMCSRL0/TMCSRL1:CNTE = 0) state. Also,
always use a word transfer instruction (MOVW 003AH, A etc.) to write a value to this register.
• Although the 16-bit reload register (TMRD0/TMRD1) is functionally a write-only register, it is
allocated to the same address as the read-only 16-bit timer registers (TMR0/TMR1). Accordingly,
since the read value is used as the TMR0/TMR1 value, the INC/DEC instruction and other
instructions for read-modify-write (RMW) operations cannot be used.
15 14 13 12 11 10 9 8
W
X
W
X
W
X
W
X
W
X
W
X
W
X
W
X
D15 D12 D11 D10 D09 D08
7 6 5 4 3 2 1 0
16-bit Reload Register (Upper)
16-bit Reload Register (Lower)
TMRD0/TMRD1
TMRD0/TMRD1
Initial value
Read/write
W
X
W
X
W
X
W
X
W
X
W
X
W
X
W
X
Initial value
Read/write
D07 D06 D05 D04 D03 D02 D01 D00
D13
D14
Address: ch.0 000085
H
ch.1 000089
H
Address: ch.0 000084
H
ch.1 000088
H
bit
bit