Curtiss-Wright | EL120 Rev. G PN60914 10/10/19
40
GGG = Controller Feedback Option
Three character code designating a Controller that uses one of the following
Resolver, Standard Encoder, Absolute Encoder
The Controller also will designate whether Thermal Protection is performed
With a Thermik Normally Closed Switch; or a Philips KTY84 Series Thermister
H = Motor Stator
1 = 1 Stack Motor
2 = 2 Stack Motor
3 = 3 Stack Motor
I = Rated Voltage
1 = 115 Volt RMS
3 = 230 Volt RMS
5 = 400 Volt RMS
6 = 460 Volt RMS
H = Motor Poles
8 = 8 Pole Motor
II = Rated Motor Speed at Rated Voltage (4500 RPM Max)
01
– 45 Two Digit Number x 100 = Rated RPM
MM = Mechanical Option
AR = External Anti-Rotate Assembly
RB = Rear Brake
INSTALLATION
Mechanical Installation
Lubrication
EL series actuators are shipped from the factory fully greased and ready for installation.
Exlar
’s standard grease is Mobil SHC 220, which is a high performance, extreme-pressure
grease. SHC 220 is adequate for a broad range of applications. In the case of extreme
temperatures, Exlar recommends using Mobilgrease 28, also a high performance, extreme-
pressure grease. The unique physical properties of the synthetic base oil provide
outstanding protection against wear, rust, corrosion, and high or low-temperature
degradation. Mobilgrease 28 allows for very low starting and running torque values. Its
operating range is -55 to 180 °C (-67 to 356 °F).
Other lubricants can be used as well and all special grease can be specified via
the “XL”
designation in the Options portion of the model mask with the appropriate product identified
with Exlar Application engineering at the time of order.
Mounting Configurations
The actuator have provisions for front face, rear face, front flange, rear eye, or rear
clevis mounting. Every effort should be made to minimize misalignment. Any misalignment
will decrease the life of the components within the actuator and also may create problems
within the application associated with misalignment.
See an Exlar catalog or Exlar Supplied mounting drawing for the specific mounting
dimensions required for your configuration.
Summary of Contents for EL120
