E L C O p e r a t i o n M a n u a l
For more information visit:
w w w. e a t o n . c o m
MN05003006E
1-56
1.3.4 Installation
and
Wiring
1.3.4.1 Installation
Install the ELC in an enclosure with sufficient space around it to allow heat dissipation, as shown in
the figure below.
z
DIN Rail Mounting:
The ELC can be secured to a cabinet by using 35mm height and 7.5mm
in depth DIN rail. When mounting the ELC to 35mm DIN rail, be sure to use the retaining clip to
stop any side-to-side movement of the ELC and reduce the chance of wires coming loose. The
retaining clip is at the bottom of the ELC. To secure the ELC to DIN rail, pull the clip down,
place it onto the rail and push the clip back up. To remove the ELC, pull the retaining clip down
with a flat screwdriver and remove the ELC from the DIN rail.
z
Direct Mounting:
Use M4 screws for direct mounting of the product.
1.3.4.2 Terminal
Torque
1. Use the 12-24 AWG single-core wire or the multi-core wire for the I/O wiring. The ELC terminal
screws should be tightened to 3.80 kg-cm (3.30 in-lbs) and please use 60/75°C copper
conductor only.
24-12AWG
< 1.5mm
2. DO NOT wire empty terminals. DO NOT place the input signal wire and output power wire in
the same wiring circuit.
3. DO NOT drop tiny metallic conductors into the ELC during installation..
z
Please attach the dustproof sticker to the ELC before the installation to prevent conductive
objects from dropping in.
z
Tear off the sticker before running the ELC to ensure normal heat dissipation.
1.3.4.3 Power
Supply
The power input type for ELCM-PH/PA model is AC. When operating the ELCM-PH/PA, please note
the following points:
1. The range of the input voltage should be 100 ~ 240VAC. The power supply should be
