InteliDrive DCU Industrial 3.4.0 Global Guide
10
Starts the engine in
OFF-RUN
. mode.
Stops the engine in
OFF-RUN
. mode (hold time =1 sec).
GREEN = Engine running.
RED (blink) = Alarm list contains not confirmed alarm.
RED (lit) = Alarm list contains confirmed alarm.
Button for Close load or Clutch Binary output control.
Cycles through the display screens MEASUREMENT->ADJUSTEMENT-
>HISTORY.
Select the set point, select the screen or increase set point value.
Select the set point, select the screen or decrease set point value.
Confirm set point value.
Note:
Stop
button hold time is 0.5 sec. to avoid unwanted engine stop.
The 2nd (0.5 sec) push of the
Stop
button cancels the ‘cooling state’ of the engine and stops the engine
immediately. To avoid the cancel of the ‘cooling state’ by the 2nd push of the
Stop
button, use LBI card of the
DriveConfig tool and make the association of
Access Lock
to the
Cooling
logical binary output of the ‘Source’
column. It causes locking of the front panel buttons during the Cooling state.
2.1.1 Controller screens
There are three screen groups available on ID controller: Measuring – Setpoints – History.
Measuring screen will be divided to more groups – ID-DCU Industrial, BIN/BOUT, AIN.
Summary of Contents for InteliDrive DCU Industrial
