ComAp InteliDrive DCU Industrial, Global Manual

Page: 272 / 350

InteliDrive DCU Industrial 3.4.0 Global Guide
272
Value group Info Related FW 3.4.0
Resolution [units] [-]
Comm object 8546 Related applications AS​
Description
Bits of this value show "1" if the controller receives messages from the controller which has address
corresponding with the bit position. Bit 0 represents address 1 etc. This value contains information about
controllers with addresses 1-16.
Note: The bit which corresponds to the own controller is always set to "1".
CAN16
6
back to List of values
Value group Info Related FW 3.4.0
Resolution [units] [-]
Comm object 8827 Related applications AS​
Description
Bits of this value show "1" if the controller receives messages from the controller which has address
corresponding with the bit position. Bit 0 represents address 17 etc. This value contains information about
controllers with addresses 17-32.
Note: The bit which corresponds to the own controller is always set to "1".
CAN32
6
back to List of values
Value group Info Related FW 3.4.0
Resolution [units] [-]
Comm object 9654 Related applications AS, SS
Description
Displays the source (protocol) of the currently received DTC error message. Diag Code is currently used
only for information in History. After writing to History Diag Code is reset back to ####.
List of possible values:
Code Source / protocol
0 ####
1 J1939-DM1
2 J1939-KWP2000
3 J1587-PID
4 J1587-SID
5 J1587-PPID
6 J1587-PSID
7 MODBUS
8 J1939-MTU
Diag Code
6
back to List of values