ComAp InteliDrive DCU Industrial, Global Manual

Page: 110 / 350

InteliDrive DCU Industrial 3.4.0 Global Guide
110
Setpoint group
Communication
Settings
Related FW 3.4.0
Range [units] 1 .. 10 [s]
Default value 5
Force value
Alternative config
NO
Step 1
Comm object 1000 Related applications AS, SS
Description
This setpoint adjusts the timeout for detection of CAN2 terminals communication failure.
CAN2 Timeout
6
back to List of setpoints
Setpoint group
Communication
Settings
Related FW 3.4.0
Range [units] 1 .. 32 [-]
Default value 1
Force value
Alternative config
Step 1
Comm object 24537 Related applications AS, SS
Description
Controller identification number. Each controller in the group has to have its own unique number. Default
value is 1.
Note: The InteliDrive ControllerAddr must correspond to InteliMonitor or DriveConfig communication
setup setting when opening Direct or Modem connection.
ControllerAddr
6
back to List of setpoints
Setpoint group
Communication
Settings
Related FW 3.4.0
Range [units] [ENABLED, DISABLED, EXTERNAL]
Default value ENABLED
Force value
Alternative config
Step [-]
Comm object 10353 Related applications AS, SS
Description
This setpoint is used to disable reading of diagnostic codes from ECU if an external diagnostic tool is
connected to engine.
Message ECU Diag disabled is displayed in the alarm list while ECU diagnostics is disabled.
The ECU Diagnostic is disabled/enabled using LBI: ECU DiagBlck binary input in case of setting to
EXTERNAL.
ECU Diag
6
back to List of setpoints