Cisco IE 4000, Software Configuration Manual

Page: 969 / 1066

965
Configuring Cisco IOS IP SLAs Operations
How to Configure Cisco IOS IP SLAs Operations
Command Purpose
1. configure terminal Enters global configuration mode.
2. ip sla operation-number Creates an IP SLAs operation, and enters IP SLAs configuration mode.
3. udp-jitter { destination-ip-address
| destination-hostname }
destination-port [ source-ip
{ ip-address | hostname }]
[ source-port port-number ]
[ control { enable | disable }]
[ num-packets
number-of-packets ] [ interval
interpacket-interval ]
Configures the IP SLAs operation as a UDP jitter operation, and enters UDP
jitter configuration mode.

destination-ip-address | destination-hostname —Specifies the destination
IP address or hostname.

destination-port —Specifies the destination port number in the range from
1 to 65535.

(Optional) source-ip { ip-address | hostname } — Specifies the source IP
address or hostname. When a source IP address or hostname is not
specified, IP SLAs chooses the IP address nearest to the destination.

(Optional) source-port port-number —Specifies the source port number in
the range from 1 to 65535. When a port number is not specified, IP SLAs
chooses an available port.

(Optional) control —Enables or disables sending of IP SLAs control
messages to the IP SLAs responder. By default, IP SLAs control messages
are sent to the destination device to establish a connection with the IP
SLAs responder.

(Optional) num-packets number-of-packets —Enters the number of
packets to be generated. The range is 1 to 6000; the default is 10.

(Optional) interval inter-packet-interval —Enters the interval between
sending packets in milliseconds. The range is 1 to 6000; the default value
is 20 ms.
4. frequency seconds (Optional) Sets the rate at which a specified IP SLAs operation repeats. The
range is from 1 to 604800 seconds; the default is 60 seconds.