Baumuller BUS 6-T Series, Technical Description And Operations Manual

Page: 88 / 119

Parameters Parameter set 0
82
Controller BUS 6 T
5.94017.06
Baumüller Nürnberg GmbH
7.4.4 Messages - monitoring
Parameter overview
ID no. Name Range
min. ... max.
Unit Standard
value
Display
only
messages - monitoring
124 speed threshold n
min
6.0000 ... 600.0000 rpm 100
157 velocity window 6.0000 ... 600.0000 rpm 120
125 velocity threshold n
x
6.0000 ... 1200.0000 rpm 100
32829 velocity threshold n
max
1200.0000 ... 12000.0000 rpm
32831 maximum intermediate circuit voltage
threshold 20 ... 800 V
126 torque threshold M
dx
10.0 ... 100.0 %
32830 response time Pzkx (M
dx
) 0.100 ... 30.000 s
32931 voltage failure time 0.000 ... 60.000 s 0
Parameter description
speed threshold n
min
The zero-speed window describes the velocity deviation from n = 0 as an absolute value.
If the actual velocity value is inside the zero-speed window the drive sets the message
n
act
= 0 (ID no. 331).
Display via LED H403 yellow or via relay contacts X3:9 and X3:10 on printed circuit board
3.9211.
velocity window
The drive sets the velocity-dependent messages whenever the measured velocity value
exceeds or falls below the respective velocity comparison value and is inside the velocity
window.
velocity threshold n
x
If the actual velocity value falls below the velocity threshold n
x
, the drive sets the message
n
act
< n
x
(ID no. 332) in Class 3 Diagnostics.
velocity threshold n
max
The maximum permissible ve 10 % is set via this parameter. On exceeding the
threshold the controller is inhibited and and the Class 1 Diagnostics error message set.
maximum intermediate circuit voltage threshold
This parameter is set to the maximum intermediate circuit voltage as standard. On
exceeding the maximum threshold, pulse inhibit takes place.