Baumuller BUS 6-T Series, Technical Description And Operations Manual

Page: 43 / 119

Leistungsteilkennung Inbetriebnahme
Controller BUS 6 T
37
Baumüller Nürnberg GmbH
5.94017.06
6.1 Identification power unit
SV 03.06H (SM) and 83.01H (AM)
•
EEPROM not yet programmed or „Motor data acknowledged“ (ID no. 32917) = 0,
but type of power unit correctly recognized.
Consequence:
The motor parameter are initialized with the data from boot-EPROM and because of the
successfully recognition of the power unit´s type the parameter of the power unit are correctly
initialized.
Error message:
- Software error BUS (ID no. 32908) wrong type of motor (bit no. 10)
NOTE
This error can´t be deleted!
Motor parameter corresponding to the motor type must be inizialized and with the
command „motor data acknowledged“ (ID no. 32917) = 1 confirmed. The new data
has to be stored with the „command store“ (ID no. 32841).
•
Change of a already programmed controller to another type of power unit.
Consequence:
If the new power unit type is recognized correctly, all data except of:
- Nominal current amplifier ID no. 112
- Maximum current amplifier ID no. 110
- Amplifier warning temperature ID no. 200
- Amplifier shut down temperature ID no. 203
- Maximum intermediate circuit voltage ID no. 32831
are read from the EEPROM (in software versions before, all data was replaced by boot data).
Error message:
- Error software BUS (ID no. 32908) wrong type of power unit (bit no. 11)
NOTE
Error can be deleted with „reset“!
If the new data isn´t stored in the EEPROM this error appears at every new switch on.
•
Power unit type isn´t recognizes at all.
Error message:
- Error software BUS (ID no. 32908) wrong type of power unit (bit no. 11)
power unit type not recognized (bit no. 2)
- Error hardware BUS (ID no. 32907) Error in recognizing power unit type (bit no. 9)
NOTE
This errors cann´t be deleted!