Barco MCM-50, User Manual

Page: 119 / 147

12. Maintenance
12. MAINTENANCE
About this chapter
This chapter contains information about the timing of maintenance tasks and it includes details about the maintenance procedures
that can be performed by the operator or by quali
fi ed technical service personnel.
This chapter also lists the basic troubleshooting tips to be followed in case of an irregularity.
Overview
• Maintenance: general overview
• Cleaning housing and mechanical structure
• Firmware upgrade
• Diagnostics through the OSD
• Diagnostic LEDs
• Identi fi cation
• Internal and scaled patterns
• Troubleshooting checklist
12.1 Maintenance: general overview
Introduction
This section lists the maintenance tasks and when they should be performed. Details on how these tasks must be performed can
be found in the following sections.
Condition based maintenance
The table below lists the maintenance tasks that must be performed on certain conditions.
Condition Maintenance task description To be performed by
New version of device
software Upgrade the device software depending on the necessity Barco trained and quali fi ed
engineer
Changes in device
settings Make a backup of the device using Support tool Barco trained and quali fi ed
engineer
12.2 Cleaning housing and mechanical structure
Cleaning the housing and mechanical structure
1. Power down the unit and unplug the power cord.
2. Clean with a damp cloth.
3. Remove stubborn stains with a cloth lightly dampened with a mild detergent solution.
12.3 Firmware upgrade
Upgrade tool
The name of the upgrade tool is according to this format:
Two main parts can be seen:
R5909057 MCM-50 17/05/2016 115