12. Maintenance
No image appears on the display.
Situation
Solution
No source is selected.
Select a source via the OSD.
No source signal can be found.
1.
Check if the projector is operational.
2.
Check if the MCM-50 output mode and the projector input
mode are matching.
MCM-50 is in standby state.
Switch to active state.
Artefacts are visible on the display.
Situation
Solution
Noise
1.
Check the IG.
2.
Check the cabling and connections.
The image on the display is poor.
Situation
Solution
Bad soft edge
In case of electronic soft edge, switch ON the soft edge.
Bad brightness or contrast
Adjust the brightness/contrast.
No control
Situation
Solution
No RCU control
1.
Remove blocking objects.
2.
Program the correct address.
3.
Insert new batteries.
122
R5909057 MCM-50 17/05/2016
Summary of Contents for MCM-50
