Barco MCM-50, User Manual

Page: 97 / 147

11. Expert operation
Image 11-35
3. Click Adjust to open the Soft Edge Edit dialog.
Image 11-36
4. Select one of the edges where blanking is required. See "Selecting an anchor point", page 100.
5. Select Level 1. See "Selecting an anchor point", page 100.
6. Adjust the position of anchor points zero and four. See "Selecting an anchor point", page 100, "Moving an anchor point in small
steps", page 100 and "Moving an anchor point in large steps", page 101.
7. If you need to further shape the blanking area on the selected side, proceed to Level 2. See "Selecting an anchor point", page
100.
8. Adjust the position of anchor point two if required. See "Selecting an anchor point", page 100, "Moving an anchor point in small
steps", page 100 and "Moving an anchor point in large steps", page 101.
9. If you need to further shape the blanking area on the selected side, proceed to Level 3. See "Selecting an anchor point", page
100.
10.Adjust the position of anchor points one and three if required. See "Selecting an anchor point", page 100, "Moving an anchor
point in small steps", page 100 and "Moving an anchor point in large steps", page 101.
11.Exit the menu.
Adjusting Black Level
1. Project a full black image.
2. Activate the created Soft Edge. See "The Soft Edge selection dialog", page 96: set checkbox Internal .
3. Browse to Display setup > Soft-edge and alpha beta planes > Black level... and press ENTER to open the Black level dialog.
R5909057 MCM-50 17/05/2016 93