11. Expert operation
As soon as the
Soft Edge edit
dialog is displayed, the
fi
rst anchor point of Level 1 is by default selected.
11.2.8 Selecting an anchor point
Description
In
Select mode
, you can select any of the anchor points. You cannot adjust or edit the selected anchor point in this mode. All actions
that can be performed in Select mode are explained in the
Help
section of the
Soft Edge edit
dialog.
Selecting an anchor point
1. Open the
Soft Edge edit
dialog by clicking
Adjust
in the
Soft Edge selection
dialog.
Image 11-49
2. Use the arrow keys
◄
and
►
on the RCU to select another anchor point in the same level.
3. Use the arrow key
▲
on the RCU to go to a higher level. If you are at Level 1, pressing
▲
activates the
fi
rst anchor point on the
next edge of the image.
4. Use the arrow key
▼
on the RCU to go to a lower level. If you are at the lowest level in your selection (see the setting in the
Soft
Edge selection
dialog), pressing
▼
activates the
fi
rst anchor point on the previous edge of the image.
5. If the correct anchor point is selected (indicated by a red square around it), press
ENTER
to go to Adjust mode or press
BACK
to return to the
Soft Edge selection
dialog.
11.2.9 Moving an anchor point in small steps
Description
Adjust mode
is used to do small Soft Edge adjustments using the arrow keys on the RCU. Each step is only one pixel. The actions
that can be performed in Adjust mode are explained in the
Help
section of the
Soft Edge edit
dialog.
For larger adjustments the
Adjust mode
is not ideal. In this case the use of the
Edit mode
and
Change mode
is more appropriate.
Using the arrow keys to move an anchor point
1. From the
Soft Edge edit
dialog, press
ENTER
or
BACK
to navigate to
Adjust mode
.
Image 11-50
2. On the RCU, press
◄
or
►
multiple times of keep the arrow pressed to move the selected anchor point in the direction of the
X-axis.
3. Press
▲
or
▼
multiple times or keep the arrow pressed to move the selected anchor point in the direction of the Y-axis.
100
R5909057 MCM-50 17/05/2016
Summary of Contents for MCM-50
