Barco MCM-50, User Manual

Page: 29 / 147

6. Setup and configuration
6. SETUP AND CONFIGURATION
About this chapter
This chapter explains the setup and con fi guration of the MCM-50.
Overview
• Setting the RCU address
• Powering the MCM-50
• Activating the MCM-50
• Setting the MCM-50 address
• Network con fi guration
• Linking MCM-50 devices in a multi-channel system
Basic setup (example)
The drawing below is a representation of a random basic setup of a F50 projector using the MCM-50 external warp box.
DP 1
DP 2
MENU
B
A CK
ENTER
1
2
+
-
+
-
+
-
+
-
+
-
3
4
5
6
7
8
9 PA
UZE
A U TO IMA
GE
SDI
D
VI VID
EO RG
B
S-
VID EO
PC
LOGO
PIP
0
CONTR
TINT
PH
A SE
CO LOR BRIGHTN
PIP A
DJ U
ST
100-240V
50-60Hz
Source 1 Source 2
5
4 3
2 1
Image 6-1
1
DisplayPort connection with input channel 1.
2 DisplayPort connection with input channel 2.
3 DisplayPort connection for channel A between MCM-50 and DP 1 on F50 series projector.
4 DisplayPort connection for channel B between MCM-50 and DP 2 on F50 series projector.
5 Dedicated stereo emitter cable.
6.1 Setting the RCU address
RCU address
To establish communication, the RCU (Remote Control Unit) address must be set to the same value as the MCM-50 IR (or RC5)
address. The user can change the IR address of the MCM-50 at any time. If you do so, the RCU address must be reprogrammed
accordingly.
Two addresses can be set in the MCM-50: a common address and an MCM-50 address. The common address can be used to
address multiple devices at once, while the MCM-50 address is used to address one single device at a time.
The default address for the RCU is 0.
R5909057 MCM-50 17/05/2016 25