![background image](http://html1.mh-extra.com/html/arteche/smart-p500/smart-p500_instruction-manual_2977391065.webp)
1BPROTECTION FUNCTIONS
PROTECTION, CONTROL AND METERING FUNCTIONS
2.1.1.2.1. SETTING RANGES (6 GROUPS)
The settings for this function are independently set for the phases. Table 2-2
Settings range for the phase time
Settings
Minimum
Maximum
Step
Observations
Enable
YES/NO
Pickup(A)
0,02
20
0,001
For In =1 A
0,1
100
0,001
For In = 5 A
Time Multiplier (dial)
0,05
1,09
0,01
For IEC curves
0,5
30
0,01
For ANSI curves
0,5
15
0,01
For US curves
Time Adder
0
100
0,01
Minimun Response Time
Adder
0.013
1
0.001
Definite Time(s)
0
600
0,01
Table 2-2 Settings range for the phase time overcurrent elements
The electromechanical reset option is available which simulates the disc used in
electromechanical protections. For definite time the protection sends the trip signal
t seconds, after the activation of the pickup, t being the Definite Time setting.
Using curves, the time for the trip signal to be sent depends on the selected curve
(family and modifiers) and on the fault current. Protection functions are evaluated
every quarter of a cycle at the fundamental frequency and a half cycle acting time
can be achieved depending on the magnitude of the fault current.
Appendix I shows the equations for the time calculation as a function of the fault
current and the pickup current.
2.1.1.3. INSTANTANEOUS OVERCURRENT ELEMENTS (50P)
Two instantaneous elements are available (low level and high level) with an
additional time option Figure 2-2 shows the logical diagram of the instantaneous
phase overcurrent low level function.
Two instantaneous elements (low and high level)
Additional time
Summary of Contents for smART P500
