Xerox ColorQube 9303 Series, Руководство по обслуживанию

Страница: 128 / 1812

February 2013
2-104 ColorQube® 9303 Family
12L-110
Status Indicator RAPs
NOTE: If the SH1 priming sensor does not see staples in the primed position, the staple head
cycles a number of times to prime the staple head. This occurs when the LCSS interlocks are
made.
Follow the customer instruction label inside the LCSS front door to remove the staple cartridge,
slide out the top sheet of staples from the cartridge, to expose a fresh sheet of staples on the
top of the stack. Ensure the forming plate is fully closed,
Figure 2 . Install the staple cartridge
and close the door. The stapler will now cycle a few times to feed and prime the new sheet of
staples. Open the door and remove the staple cartridge. Examine the sheet of staples that
have been fed to the staple forming part of the stapler, by opening the forming plate,
Figure 3 .
The first two staples have been partially formed.
Y
N
Install a new staple cartridge,
PL 26.10 Item 16 and repeat the check. If the first two sta-
ples are not partially formed install a new staple head unit, PL 12.55 Item 5 . Perform SCP
5 Final Actions
Install a new staple head unit, PL 12.55 Item 5 . Perform SCP 5 Final Actions.
Figure 1 Component location
Figure 2 Staple cartridge closed
Staple head unit
SH1 paper sensor
Q12-196
Forming plate
closed
Primed staples
A