Xerox ColorQube 9303 Series, Руководство по обслуживанию

Страница: 142 / 1812

February 2013
2-118 ColorQube® 9303 Family
12-151-171, 12-152-171
Status Indicator RAPs
12-151-171, 12-152-171 HVF Compiler Exit Sensor RAP
12-151-00-171 The paper trailing edge is late leaving the compiler exit sensor.
12-152-00-171 The paper leading edge is late arriving at the compiler exit sensor.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
GP 14 . Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Check for a jam or other obstruction in the paper guide.
• Check the paper guide for damage.
Procedure
Enter dC330 , code 12-106. Manually actuate the compiler exit sensor, Q12-106, Figure 1 .
The display changes.
Y
N
Go to
WD 12.7 . Check the sensor, Q12-106.
Refer to:
• GP 11 How to Check a Sensor.
• 12A-171 HVF Power Distribution RAP
• 01L 0V Distribution RAP
Install new components as necessary:
• Compiler exit sensor, PL 12.135 Item 2 .
• HVF PWB, PL 12.140 Item 2 .
Enter dC330 , code 12-225. Energize the exit diverter solenoid SOL12-225, Figure 1 . The
solenoid energizes.
Y
N
Go to
WD 12.8 . Check SOL12-225.
Refer to:
• GP 12 How to Check a Solenoid or Clutch.
• 12A-171 HVF Power Distribution RAP.
• 01L 0V Distribution RAP
Install new components as necessary:
• Exit diverter solenoid, PL 12.120 Item 4 .
• HVF PWB, PL 12.140 Item 2 .
Enter dC330 , code 12-224 to run the transport motor 2, MOT 12-224, Figure 1 . The motor
runs.
Y
N
Go to
WD 12.8 . Check the transport motor 2, MOT 12-224.
Refer to:
• GP 10 How to Check a Motor.
• 12A-171 HVF Power Distribution RAP
• 01L 0V Distribution RAP
Install new components as necessary:
• Transport motor 2, PL 12.120 Item 1 .
• HVF PWB, PL 12.140 Item 2 .
Check the transport motor 2 drive belt. The drive belt is good.
Y
N
Install a new transport motor 2 drive belt,
PL 12.120 Item 10 .
The fault may be intermittent, check for damaged wiring or bad connectors, REP 1.1 . If neces-
sary install new components:
• Compiler exit sensor, PL 12.135 Item 2 .
• Exit diverter solenoid, PL 12.120 Item 4 .
• Diverter gate, PL 12.125 Item 7 .
• HVF PWB, PL 12.140 Item 2 .
Figure 1 Component location
Compile exit sensor
(Q12-106)
Exit diverter solenoid,
SOL12-225
Transport motor 2 - Exit
(MOT12-224)
A
A