Xerox ColorQube 9303 Series, Руководство по обслуживанию

Страница: 190 / 1812

February 2013
2-166 ColorQube® 9303 Family
12D-171
Status Indicator RAPs
Figure 3 Booklet skew
If the booklet skew does not conform to the specification in Table 4 , perform the following:
1. Check the operation of the BM stack hold solenoids, refer to the 12-065-00-171, 12-383-
00-171 HVF Booklet Back Stop Failure RAP. If the stack hold solenoids are operating cor-
rectly, check for any contamination or debris in the compiling area of the BM, that could
cause the mis-alignment.
2. ADJ 12.9-171 Booklet Marker Skew.
3. Check the BM back stop assembly for damage. If necessary, install a new BM back stop
assembly,
PL 12.165 Item 18 .
Booklet Crease is Off Centre
Figure 4 , open out the booklet at the centre page and press it onto a flat surface. Measure the
position of the booklet crease.
Figure 4 Booklet crease position
Table 4 Skew tolerance
Paper weight
Paper size A4,
8.5x11in,
8.5x13in or
8.5x14in Paper size A4,
8.5x11in,
8.5x13in or
8.5x14in
Paper size A3
or 11x17in Paper size A3
or 11x17in
-
95% of
booklets 99.7% of
booklets
95% of booklets
99.7% of
booklets
80gsm (20lb) Less than
1.0mm Less than 2.5mm Less than
1.4mm
Less than
3.1mm
All other booklet
maker approved
weights in GP 20 Less than
1.5mm Less than 3.0mm Less than
2.1mm
Less than
3.6mm
The amount of skew is the difference
between the two measurements
Table 5 Crease position and tolerance
Paper size Edge to crease measurement
A4 148.5 +/- 1.5mm
A3 210 +/- 1.5mm
8.5x11 inch 139.5 +/- 1.5mm
8.5x13 inch 165.1 +/- 1.5mm
8.5x14 inch 178.0 +/- 1.5mm
11x17 inch 216.0 +/- 1.5mm
Measure from the booklet
edge to the crease