Xerox ColorQube 9303 Series, Руководство по обслуживанию

Страница: 189 / 1812

February 2013
2-165 ColorQube® 9303 Family
12D-171
Status Indicator RAPs
If the top and bottom edge alignment does not conform to the specification in Table 2 , check
the operation of the BM tampers, refer to the 12-066-00-171, 12-384-00-171, 12-419-00-171,
12-420-00-171 HVF BM Tamper Failure RAP. If the tampers are operating correctly, go to ADJ
12.5-171 Booklet Tamping and check the tampers are correctly adjusted.
If the booklet skew does not conform to the specification in Table 4 . Perform the following:
• Check the operation of the BM stack hold solenoids, refer to 12-065-00-171, 12-383-00-
171 HVF Booklet Back Stop failure RAP.
• If the stack hold solenoids are operating correctly, check for contamination or debris in the
compiling area of the BM that could cause the mis-alignment.
Open Side Edge Alignment
Figure 2 , open out the booklet at the centre page and press it onto a flat surface. Measure the
mis-alignment of the open side edges of the booklet.
Figure 2 Open side edge alignment
If the open side edge alignment does not conform to the specification in Table 3 , check the
operation of the BM stack hold solenoids, refer to the 12-065-00-171, 12-383-00-171 HVF
Booklet Back Stop Failure RAP. If the stack hold solenoids are operating correctly, check care-
fully for any contamination or debris in the compiling area of the BM, that could cause the mis-
alignment.
Badly Formed Booklet Staples
If the booklet staples are not formed correctly, perform ADJ 12.3-171 Staple Anvil Alignment.
Booklet Compiler is Not Correct
If the page order of the booklets is not correct, perform ADJ 12.6-171 Booklet Compiling Posi-
tion.
Skewed Booklet Crease
Figure 3 , open out the booklet at the centre page and press it onto a flat surface. Measure the
amount of booklet skew.
Table 3 Open side edge alignment
Paper weight 95% of booklets 99.7% of booklets
80gsm (20lb) 1mm 2mm
All other BM approved weights in GP 20 2mm 3mm
Measure the total scatter