Xerox ColorQube 9303 Series, Руководство по обслуживанию

Страница: 1707 / 1812

February 2013
8-13 ColorQube® 9303 Family
Principles of Operation
Tray 5
The optional Tray 5, Figure 20 , is positioned on the left-hand side of the IME (when viewed
from the front) and feeds media into the IME through a slot in Door A, below the bypass tray.
The unit undocks from the IME to allow jam access through Door A.
The PFP consists of the following major elements:
• Single media tray
• Media lift drive
• Feeder
• Controller Board
Figure 20 Tray 5 location
Finishing Options
The following finishing options are available:
• Offset Catch Tray (OCT)
• Low Capacity Stacker / Stapler (LCSS)
• High Volume Finisher (HVF).
Offset Catch Tray (OCT)
Figure 21 . The Offsetting Catch Tray (OCT) is an optional output device attached to the right
hand side of the IME. Output is stacked face down or face up in the tray. The user can select to
have alternate sets offset from one another to provide set distinction, including single sheet
sets. A fill sensor is activated when the tray reaches 90% capacity.
Figure 21 OCT location
Low Capacity Stacker/Stapler (LCSS)
Figure 22 . The LCSS provides collating, stacking, stapling and hole punching operations on
paper delivered center registered, face-up or face-down from the IME. The LCSS offers two
trays: a stacker tray with a capacity of up to 2000 sheets, and a top tray with a capacity of up to
100 sheets. The user may select from up to three stapling options (single front corner, single
front edge and dual) dependant on paper size and orientation. Punch operations include two,
three or four-hole options in accordance with the selected mode.
Figure 22 LCSS location