Xante PlateMaker 3, Руководство пользователя

Страница: 261 / 298

_____________________________________ Printer Options 10-17
a. Carefully slide the interface bracket on the printer. You
may have to squeeze the parallel connector locks
together as you put the bracket on.
b. Replace the hex nuts on each side of the serial port.
c. Replace the two bracket screws.
Replacing the Controller Board Panel
After installing the upgrade(s), replace the controller board panel.
1. Insert the tab on the top of the controller board panel into the
slot above the opening (fig. 10.6).
2. Align tabs on the front of the controller board panel with the
slots in front of the opening; then slide the panel forward into
place (fig. 10.6).
3. Secure the controller board panel to the printer by tightening
the screws on the back of the panel (fig. 10.5).
4. Reconnect all interface cables and the power cable to the
printer and the AC power supply.
Internal IDE Hard Disk Upgrade
The internal hard disk upgrade provides extra space to store
downloaded fonts and allows you to implement the Font Accelerator
and spooling features on your printer. This upgrade is performed at
the factory. See “Printer Options” earlier in this chapter to order the
upgrade. See “Font Accelerator” and “Spooler” in chapter 6 and
“Procedures” in chapter 3 (Macintosh) or 4 (PC).
◊ ◊ ◊