Xante PlateMaker 3, Руководство пользователя

Страница: 259 / 298

_____________________________________ Printer Options 10-15
Installing the Ethernet Board
The Ethernet upgrade for the PlateMaker 3 allows you to run
EtherTalk, Novell Print Server, NetBEUI, and Line Printer protocols
on your printer. After installing the Ethernet upgrade, see chapter 6
for information about configuring and using the Ethernet options.
Required tools: • A small magnetized Phillips screwdriver
• A 3/16" hex nut driver
1. Remove the controller board panel following the instructions
earlier in this section.
2. Unpack the Ethernet upgrade and verify that it contains the
following items:
• Ethernet board • Ethernet interface panel
3. Remove the interface bracket from the printer (fig. 10.11)
using the following procedure.
Fig. 10.11 Remove the Interface Bracket
a. Remove the two bracket screws with the Phillips
screwdriver.
b. Remove the hex nuts on each side of the serial port.