Xante PlateMaker 3, Руководство пользователя

Страница: 256 / 298

10-12 Printer Options bb ____________________________________
Installing SODIMMs or SIMMs
RAM SODIMMs are installed in the DRAM banks (see previous
section); flash and FIFO SIMM banks are labeled in fig. 10.8. The
RAM SODIMMs and the flash and FIFO SIMMs are different sizes
and only fit in the correct banks.
SODIMMS
Bank 1/1
Bank 1/0
Bank 0/1
Bank 0/0
Flash ROM SIMM Bank
Fig. 10.8 Flash SIMM and SODIMM Banks
1. Remove the controller board panel following instructions
earlier in this chapter.
2. Unpack the SIMM or SODIMM.
3. Remove the existing SIMM or SODIMM if necessary using
the following procedure.
a. Pull open the latches on each end of the SIMM or
SODIMM bank.
Note: As a SIMM is released by the latches, it tilts out
of the bank (fig.10.9). A SODIMM does not tilt
(fig.10.10).