Xante PlateMaker 3, Руководство пользователя

Страница: 196 / 298

6-22 Configuration bb ______________________________________
RS232 Configuration
When using the RS232 port, you must configure the printer and PC
to use the same baud rate, parity, flow control, data bit, and stop bit
settings.
Baud rate is the rate at which serial data is sent between the
computer and the printer. The Baud Rate menu allows you to select
baud rates of 1200, 9600, and 19200. The factory default is 9600.
Parity is used to check for transmission errors by comparing the
group of data bits sent to the group received. A loss of data during
transmission usually results in a change to the group size. Parity
options are None (the factory default), Even, Odd, Mark, and Space.
Flow control is the mechanism the printer uses to signal the
computer that it is ready to accept data. The Flow Control menu
allows you to select XON/XOFF (software) or DTR (hardware) flow
control. The factory default is XON/XOFF.
The Data Bits menu allows you to select either 7 or 8 data bits. The
factory default is 8.
The Stop Bits menu allows you to select either 1 or 2 stop bits. The
factory default is 1.
Parallel Configuration
When using the Parallel interface, set the Handshaking menu
(PARALLEL:HNDSHK) for handshaking mode. Handshaking
options are Auto (Automatic), Compat (Compatible), Bidi
(Bidirectional), and ECP (Enhanced/Extended Capabilities Port).
The factory default is AUTO.
Novell Print Server Configuration
When using the Novell Print Server interface, set the printer for the
NetWare protocol frame type used on your network. You can also
specify a printer timeout on the network.
The Protocol menu allows you to select 802.3, which is the default
packet type for NetWare versions 3.12 and up, or 802.2 (NO SNAP),
which is the default packet type for NetWare versions prior to 3.12,
as the Novell protocol frame type used on your network. The factory
default is 802.3.