Xante PlateMaker 3, Руководство пользователя

Страница: 143 / 298

_______________________________________ Ethernet Setup 5-3
Introduction
This chapter covers configuration for the EtherTalk, Novell Print
Server, and Line Printer protocols on the printer’s optional Ethernet
interface using printer front panel menus, XANTÉ Command
Center, and specific network software. It also covers NetBEUI
configuration in a PC environment
EtherTalk Network Configuration
Ethernet is a multiple protocol medium that allows you to run
several network protocols concurrently. An EtherTalk network
allows you to run the AppleTalk protocol on a physical base which
can be three to five times faster than a LocalTalk network.
Note: Typically, only Macintosh computers are installed on an
EtherTalk network. If you have PCs operating in an
EtherTalk network, see the documentation that came with
your PC EtherTalk interface.
The following steps are required to set up your XANTÉ printer on an
EtherTalk network. Chapter 2 covers step 1, chapter 6 covers step 2,
and this section covers steps 3 and 4.
1. Connect your XANTÉ printer to the network through the
Ethernet port.
2. Enable the printer’s EtherTalk interface, if necessary.
3. Select the EtherTalk Phase 2 driver.
4. Change the EtherTalk Zone name, if necessary.
Select the EtherTalk Phase 2 Driver
Your printer supports EtherTalk Phase 2 on an EtherTalk network. If
the Phase 2 driver is not included with your Macintosh operating
system, call the vendor that supplied the Ethernet card for your
Macintosh.