Veeco Dektak 150, Руководство пользователя

Страница: 46 / 349

Installing the Dektak 150 System 2-19
5 Turn the knob on the exchange tool so that the green dot is visible (
Figure 2-24
) and the magnet is
engaged.
6 Holding the exchange tool from the edges, align its pins with the outside of the sensor. (Because this is a
precision alignment, you may want to practice several times without the stylus in the way.) Push up until the
tool is flush with the bottom of the sensor (see
Figure 2-25
).
Figure 2-25: Aligning the Exchange Tool with the Sensor
7 Turn the thumb wheel to disengage the exchange tool's magnet.
8 Carefully lower the exchange tool to remove it.
9 Locate the stylus shield in Box 3 (see
Figure 2-26
).
Figure 2-26: Stylus Shield
10 Place the shield around the sensor head, such that the right-front corner tab is engaged (
Figure 2-27
).
Press in on the left -rear corner tab until the shield clicks into place (
Figure 2-28
).
Ground clip
Left-rear corner
tab
Right- front
corner tab