Saab 95 1967, Руководство по обслуживанию

Страница: 150 / 610

8 Check that the crankshaft runs coolly In me uearlng
seats.
9 [JUN the connecting reds up against the crank webs
on the shaft. Put on the bearing caps with inserted
and oiled bearing inserts. Make sure that the marks
coincide. Tighten the new bolts to the prescribed
torque.
NOTE
Fit new connecting rod bolts e
very time the engine
has been disassembled.
REAR BEARING CAPS WITH MARKED SURFACES FOR 10 Apply a thin coat of sealing compound to the trans-
APPLICATION OF SEALING COMPOUND mission cover gasket surface and to the intermedi-
ate plate. Position the gasket. Install the transmis-
sion cover and center it with tool 78 62 148 until
NOTE all bolts have been tightened.
The arrows on the center and front main bearing
maps must point to the front.
6. Tighten the front and rear bearing caps to a torque
of 98 Nm (72 ft.lb., 10.0 kpm). Finger‘tighten the
bolts for the center bearing cap.
NOTE
Do not confuse the screw for cylinder heads and
main bearings. These have the same diameter, but
the screws for the main bearings are approx. 0.4 in.
(10 mm) longer than those for the cylinder heads.
As from engine No. 74900, the cylinder head screws
have been lengthened approx. 0.4 in. (10 mm) and
consequently there is no danger of confusion.
7.
Press the crankshaft forwards and pry the axial
(center) bearing cap to the rear. Then, tighten the g
cap bolts to a torque of 98 Nm (72 ft.lb., 10 kpm) 51260
while holding the crankshaft forward. (This is nec- INSTALLATION OF TRANSMISSION COVER
essary to make both halves of the bearing inserts 1. TranSmigion cover
equally ready to bear axially.) 2. Centering arbor 78 62 147
11.
Coat the inner diameter of the new crankshaft 588'
with engine oil and slide the seal onto tool 78 62 170-
Insert the seal so that the distance between the seal
and the rear of the engine block is between 0-36
and 0.38 in. (9.2 and 9.7 mm).
TOHOUING THE CENTER MAIN BEARING CAP
52415
216—2