Saab 95 1967, Руководство по обслуживанию

Страница: 560 / 610

Door lock
Replacement
1. Close the door window.
2. Remove the interior door trim.
3. Unscrew the inner door handle remote control retain-
4. Back off and remove door lock retaining screws, and
unscrew the button used to lock the door.
Release and remove the lock. Note that locks as from
model 1968 must be in "closed" position when re-
moved.
5.
REMOVAL OF DOOR LOCK
6. If necessary, the outside door handle can be removed
by backing off and removing the two retaining screws,
one inside and one on the back of the door.
To reinstall the door handle and door lock, proceed in
the reverse order to that given above. Before refitting,
check that the moving parts of the lock, and the lock
springs, are well lubricated with Saab Special Chassis
Grease.
Check with the button of the outside handle pushed in
that there is a play of about 0.04” (1 mm) when the door
is closed. If the play is less than this, adjust as follows:
a. Cars up to and incl. model 1971 : File down the part
of the push button arm that actuates the door look.
b. Cars as from model 1972: Bend the outer part of the
push button arm.
After refitting the door, adjust the striker plate so that
the door opens and closes easily.
“L, m
er. Note the return spring on cars as from model 1969.
Door striker plate
Adjustment
The striker plate is adjustable and can be moved if the
screws are slackened. Adjust the striker plate so that the
door opens and closes easily without being forced up of
down by the location of the plate.
ADJUSTMENT OF DOOR STRIKER PLATE
Lock cylinder
Removal
After removing the interior door trim, take off the out-
side door handle by removing the two retaining screws,
one inside and one on the rear edge of the door.
Disassembly, up to and incl. chassis No. 95773000541
and 96773000960
1. Up to and Incl. model 1971:
Depress the push button (7) and drive out the pin (2)
with a driver (max. 0.12 in/3 mm). Remove the arm
(1) and the washers (3 and 4).
MA“ 1077