Saab 95 1967, Руководство по обслуживанию

Страница: 563 / 610

5' Fit new door locks and put the rods loosely together
with the adjusting nuts.
6. Adjust the length of the rods so that the two door
|ockS are in the outmost position when the control
handle is standing horizontally. Tighten the lock nuts
ADJUSTMENT OF RODS. DOOR LOCK
7. Check the flush fit of the door. Adjust the striker
plates if necessary. Lubricate door lock and controls.
Refit handle and door trim.
Changing the latch
1—3. See position 1—3 "Changing door lock". Pull out
the outer handle.
4. Back off the serrated nut inside the door with the
aid of polygrip pliers.
5. Remove the chromium plated nut on the outside
of the door by placing mandrels in the two recesses
and turn with a screwdriver.
REMOVING
THE NUT
Refilove the two retaining screws and hook the
59”"9 Off the clamp, whereupon the latch can be
removed.
Put the new latch in place with the serrated nut
threaded on as far as possible. The latch should be
turned, so that the joint for the right hand side
door lock rod is facing the bottom of the door.
Hook on the spring and install the nut on the out-
side of the door,
Fit the two retaining screws and tighten the serrated
nut.
10' Fit the adIUSting nuts on the rods. Turn the latch
With the aid of the outer handle to separate the
ends of the rods so that the adjusting nuts can be
mounted.
11—
12' [Adjust rods and door according to positions 6—7
Changing door lock”.
MW-
95773000541
1. Fit the key and turn it 35° clockwise.
2. Push-In the catch pin with the aid of a mandrel or
the like and pull out the lock cylinder.
REMOVAL OF LOCK CYLINDER
3. Push in the catch pin on the new lock cylinder.
Note that this can be done only when the key is
turned 35° clockwise. Engage the lock cylinder
in the handle and check that the catch pin gets
locking position.