Saab 95 1967, Руководство по обслуживанию

Страница: 252 / 610

Changing bulbs
A headlight bulb normally has full power for the first 100
hours of the burning time. Even if the lamps work longer,
the light power decreases considerably after this time. In
order to have as much light as possible, it is therefore ad-
visable to change the headlight bulbs about once a year.
with normal driving.
Another factor of importance to effective lighting is that
the reflector is undamaged and that the cable terminals
have good contact.
1. Lift the hood and push the rubber grommet behind
the headlight out of the way.
2. Press and release the retainer spring, whereupon the
bulb socket can be withdrawn.
3. Change the bulb. Use a clean cloth or the cardboard
box when fitting the new bulb. Do not touch the bulb
by hand.
4. Refit the lamp socket, making sure that the locating
lug is correctly positioned. Make sure that the retainer
spring holds the socket properly, keeping it in the
proper position.
5. Refit the rubber grommet, making sure that it seals
properly round the socket. Check that the cable ter-
minals have good contact.
IMPORTANT
If the bulb is incorrectly located in the reflector, a
faulty light pattern will result, and it will therefore
be impossible to get a correct setting.
Alignment of right dipping and left dipping asymmetric
lights
1. Check the tire pressures and place the unladen car on
a flat surface about 16 1/2 feet (5 meters) from the
screen.
2. Switch on to dipped beam and shield one of the head-
lights.
3. Check and adjust the beam so that the horizontal part
of the light dark border is exactly 2.0 in. (50 mm) low-
er than and to the left (to the right for left dipping
asymmetric lights) of the measured headlight center
point. The sloping part of the light dark border must
be entirely to the right (to the left for left dipping
asymmetric lights) of the mark and thus meet the ho-
rizontal part exactly under the headlight center.
ALIGNMENT
OF RIGHT DIPPING ASYMMETRIC HEAD-
LIGHTS
H = Height of headlight center above ground
A = 415 mm
B = 50 mm
ALIGNMENT
OF LEFT DIPPING ASYMMETRIC HEAD-
LIGHTS
H = Height of headlight center above ground
A = 415 mm
B=50mm
4. Check the other headlight in the same way.
5. Check that the full beam is evenly distributed. If the
beam is unevenly dISt'ibUted. or if it proves difficult
t° 9“ dipped-beam settings. make sure that
the bulb is correctly fitted o
r, If necessary, fit a new
a- A.