Saab 95 1967, Руководство по обслуживанию

Страница: 573 / 610

Separalc LIIC apllllbu jun”. VVILII d SCI'erI’IVer.
Separatin backrest—seat cushion
l. R ..
emove the two Philips head screws, according to fig.
NOTE
Make sure that the eccentric does not slip out of the
hole in the locking arm. If this happens, the eccen-
triC shaft tension spring will lose its grip.
sun
REMOVAL OF SCREWS FOR THE RECLINING CONTROL
JOINT,
DISASSEMBLED . . . .
SPLINED 2. Remove the lock mg on the opposrte sIde. (The ring
m 4. Sp ‘n ' ' 1. Lock 3'. r} 9 . Is holding the back rest frame stud to the seat frame.)
2. Eccentric S. |wust ring I h n th b k
- lines . l t r e iate t e e e ac rest can be hooked off from the seat.
2. Turn the twist ring and intermediate tube counter-
clockwise until all play is eliminated and the release
button is about 0.4" (10 mm) above the stop. Put the
splined joint together in this position.
NOTE
The foregoing instructions apply to the left hand
seat. In the case of the right hand seat, turn the twist
ring and intermediate tube clockwise.
Dropping the backrest forward
To drop the backrest forward, press down catch 2 (see
illustration, page 850—4).
Sum»
REMOVAL OF LOCK RING
W
Tum kn0p 3 (see illustration, page 850—4) forward to
raise and backward to lower the backrest.
NOTEl Do not press on the backrest while adjusting-
suns 850-5